Home » Coverage Area » San Anselmo
The call we get most often from San Anselmo is a drain that has slowed to a trickle or stopped entirely, a water heater that quit overnight, or a leak that showed up as a damp patch on a wall before anyone could trace where it started. This is a town of older homes, many of them built decades ago on original supply lines that have never been touched. The plumbing in houses like these tends to work quietly for a long time, and then it does not. When that happens, the job is usually more involved than a quick patch, and getting a clear answer about what the work covers matters as much as getting it scheduled.
We handle the full range of residential plumbing repair and installation across San Anselmo, from a single fixture swap to a complete repipe. Homeowners, property managers, and landlords with rental units all call for the same basic things: a straight answer about what is wrong, a price before anything starts, and a plumber who shows up and takes care of it. We cover San Anselmo and the surrounding area, available every day from 9:00 AM to 8:30 PM.
Getting a plumber scheduled should not take most of your day. When you call, you reach someone who knows the trade and can scope the job on the phone, ask the right questions about what you are seeing, and give you a price before the visit is booked. The appointment is confirmed on that same call. Plumbing visits are scheduled without the runaround, and the scope is settled before anyone shows up so the visit stays focused on the actual work.
For problems that will not wait, we take short-notice calls within our posted hours. A burst supply line, a water heater that has stopped entirely, or a drain backing up into the house are all calls we take on short notice when the schedule has room. We confirm what is available when you book, so you know what to expect before the day of the visit.
Rental properties and occupied units get the same attention. If a tenant is in the home, we work around that. If a property manager needs to coordinate access, that happens on the call. The goal is to get the work done without making the situation harder for anyone living or working in the space.
A toilet that rocks, leaks at the base, or runs constantly is one of the more common calls we get from older homes. A rocking toilet usually means the wax ring has failed or the floor flange has shifted. Left alone, it lets water seep under the floor with every flush. We reseat the toilet, replace the wax ring, and check the flange before we put it back. When the toilet itself is the problem, cracked or simply at the end of its useful life, replacement is the cleaner fix.
An outdoor faucet that drips when shut off, or one that has corroded to the point where it will not close fully, wastes more water than most people expect over the course of a season. We repair and replace hose bibs, outdoor supply connections, and the shut-off valves that control them. Irrigation connections that have developed a slow leak at the fitting or at the backflow preventer fall within the same scope.
A leak that is not visible at the surface tends to announce itself through a damp wall, a soft spot in the flooring, a water meter that keeps moving when everything is turned off, or a water bill that has climbed without explanation. We use pressure testing and electronic detection to locate the source before any repair work starts. In older homes with cast-in supply lines, the leak is sometimes beneath the slab rather than inside the wall, and that changes the repair approach. We walk through the options before anything is opened up.
Slow drains are easier to clear before they stop completely. Kitchen drains collect grease and food debris over time. Bathroom drains catch hair and soap buildup. When a single fixture is slow, the blockage is usually in the branch line. When multiple fixtures are slow or backing up at the same time, the problem is further down in the main line. We clear drains with a cable auger for most household stoppages and hydro jetting for main-line buildup that a cable will not fully break up.
Older San Anselmo homes sometimes have sump pumps installed in low-lying areas where groundwater collects. A sump pump that is running constantly, failing to keep up, or not running at all when it should be is worth a call before the problem shows up as standing water. We handle sump pump repair and replacement as part of the broader plumbing scope, along with outdoor supply lines and the connections that feed irrigation systems and exterior fixtures. For a fuller picture of the job, see the services page.
When you call, we scope the job based on what you describe and give you a rate before anything is scheduled. The price is confirmed before the visit is booked. That is the process, and it does not change whether the job is a faucet repair or a full repipe.
What can move a quote is what the job turns out to involve once the work is underway. The two most common reasons are access and condition. A leak inside a finished wall costs more to reach than one in an open utility space. Pipe that has corroded broadly, or that turns out to be a different material than expected, may require a different repair method than the one scoped on the call. When something like that comes up, we stop and tell you before proceeding. Nothing is added to the scope without your agreement.
Calling for a quote is how it starts. Fast diagnosis. A price agreed before we start. Dry floors again.
The visit starts with a look at what you described on the call. We confirm the symptom, check the surrounding area for anything related, and run whatever diagnostic the situation calls for, whether that is a pressure test, a camera inspection of the drain line, or a closer look at the fixture or connection that is causing the problem. Plumbing done to the standard the next inspection expects means doing the diagnostic properly before deciding on the repair.
Before any work begins, we explain what we found, what the repair involves, and what it will cost. You agree to the scope before anything is opened up or replaced. If the job turns out to be simpler than expected, the price reflects that. If it is more involved, you hear about it before we proceed.
We clean up the work area before we leave. The water is restored before the visit ends, unless a repair requires a part that needs to be ordered, in which case we tell you that on the same call.
Most homes in San Anselmo are on a municipal water supply, which means water pressure is regulated at the street and again at the pressure-regulating valve inside the home. A PRV that has drifted out of range or failed is one of the more common reasons water pressure drops throughout the house, or runs higher than it should. High pressure is hard on fixtures and supply lines over time. Low pressure is a daily frustration. A pressure diagnostic on the call helps narrow down whether the issue is at the valve, in the supply line, or somewhere else in the system.
Water quality across the Bay Area region varies. Where hardness is a concern, a whole-home softener reduces the scale buildup that shortens the life of water heaters and fixtures. Where taste or sediment is the issue, a point-of-use filter or a whole-home filtration system addresses it at the supply. We install both types and connect them to the existing supply line. Local means we care what the neighbors say about our work, and that applies to filtration installs as much as to any other job.
A property on a private well needs a pressure tank, a pump, and the supply connections between them to be in good working order. A pressure tank that has lost its charge, or a pump that is cycling too frequently, shows up as inconsistent pressure at every faucet in the house. We handle the plumbing side of private supply systems, including pressure tank replacement and the supply connections that feed the house.
We serve San Anselmo and the communities nearby throughout Marin County. Along with San Anselmo, we cover Ross, Fairfax, Sleepy Hollow, Kentfield, and San Rafael. If your address is in the area and you are not sure whether it falls within our range, call and ask. We confirm coverage on the same call and get the job scoped at the same time.
Older homes in the area are more likely to have original supply lines that have never been replaced, and in some cases those lines are galvanized steel that has corroded from the inside over decades. Galvanized pipe tends to show up as discolored water, reduced pressure, and repeated leaks at fittings before it fails entirely. Copper supply lines cast into a slab foundation are common in post-war construction and are the usual source of slab leaks. We ask about the age and construction of the home on the call because it shapes what the diagnostic covers.
We can discuss that on the call. Whether a customer-supplied part is suitable for the job depends on the part, the application, and whether it matches what the repair requires. We give you a straight answer about whether the part works for the job before the visit is scheduled.
In most cases, yes, though there will be periods when the water supply is off. We work through the job in a way that restores water service at the end of each day where possible, and we tell you what to expect before work starts so you can plan around it.
A slab leak repair addresses a single identified break in a supply line running beneath the concrete foundation, either by patching the damaged section or rerouting that line through the walls. A whole-home repipe replaces the supply lines throughout the house and makes sense when leaks have repeated in different locations, or when the pipe has deteriorated broadly enough that another break is likely soon. We assess the condition of the system on the visit and walk through both options before recommending one.
If we find a second issue that is not urgent, we tell you about it and you decide whether to address it at the same visit or schedule a separate call. We do not add work to the job without your authorization.
San Anselmo and the towns around it are all covered.
Whether the call comes from Fairfax, Kentfield, or anywhere else in the area, the process is the same: call (707) 899-1595, describe what you are seeing, get a price, and pick a time.
We are available every day from 9:00 AM to 8:30 PM, including weekends. Pick the date. We do the plumbing. We clean up after.
Call (707) 899-1595 to schedule service or get a quote.
Close by, we also take plumbing work in: San Rafael, Novato, Richmond, San Pablo, Hercules.
Have a look at our coverage area list.
Below is a plain-language look at the plumbing work we handle in San Anselmo and across Marin County. Each row covers what the service includes, who it fits best, and one practical note worth knowing before you call. If a job you need is not listed or you are not sure which service applies, call us and we will scope it on the phone.
| Type of Job | What It Covers | Recommended For | Helpful to Know |
|---|---|---|---|
| Water Heater Repair & Replacement |
| Households with no hot water, inconsistent heat, or a unit showing rust or noise | Water heaters older than about ten years are worth keeping an eye on before a failure forces an emergency replacement. |
| Whole-Home Repiping |
| Homes with repeated leaks, discolored water, or low pressure throughout | Repiping is often the practical next step after a second or third slab leak in the same home. |
| Slab Leak Detection & Repair |
| Slab-on-grade homes with warm floor spots or a meter that runs overnight | North Bay soil movement makes slab leaks common in older San Anselmo neighborhoods. |
Call (707) 899-1595 to talk through what you are seeing and get a quote before anything is scheduled.